Cisco 678 Especificaciones descargar pdf (Pagina 91)

5-7

Cisco 600 Series Installation and Operation Guide

78-11190-01

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Bridging Mode Procedures

To manage the bridged Cisco 67x using a separate management VC:

Step 1

To disable in-band bridging management, enter:

set bridging management disabled

Step 2

To enable bridging PVC, enter:

set bridging PVC enabled

Step 3

To save your changes, enter:

write

Step 4

To reboot the device, enter:

reboot

After rebooting, the Cisco 67x will have two PVCs enabled. Wan0-0 is used

strictly for bridged traffic, while wan0-1 is used strictly for management traffic.

Wan0-1 will be using RFC 1483 routing.

Step 5

Set an IP address on the Ethernet port that is on the same network as the far-end

station out the wan0-1 interface:

set int eth0 address ip address

For more information on using the

set bridging

command, see the

Cisco

Broadband Operating System User Guide

The rules that govern the

bridge

command are:

•

Bridging and routing do not operate simultaneously on the Cisco 67x ADSL

router.

•

Only one bridging mode is allowed at any one time (that is, RFC 1483 or

PPP/BCP, not both).

•

The following commands do not work while in bridge mode:

–

set route

(and setting static routes)

–

RIP-related commands (

set

and

show

)

–

Filter-related commands (

set

and

show

)

–

Web interface (only allowed if management is enabled)

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 191 192

Comentarios a estos manuales

Sin comentarios

Cisco 678 Especificaciones Pagina 91

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco 678