Cisco 7300-6T3 Especificaciones descargar pdf (Pagina 43)

4-9

Cisco 7304 6-Port Clear Channel E3 Line Card Installation and Configuration

OL-5061-01

Chapter 4 Configuring the 6E3 Line Card

Checking the Configuration

Using show Commands to Verify the New Interface Status

Table 4-7 on page 4-9 demonstrates how you can use the show commands to verify that new interfaces

are configured and operating correctly and that the 6E3 line card appears in them correctly. Sample

displays of the output of selected show commands appear in the sections that follow. For complete

command descriptions and examples, refer to the publications listed in the “Related Documentation”

section on page viii.

Note The outputs that appear in this document may not match the output you receive when running these

commands. The outputs in this document are examples only.

If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is

not functioning properly, ensure that the interface is properly connected and terminated. If you still have

problems bringing up the interface, contact a service representative for assistance. This section includes

the following subsections:

• Using the show version Command, page 4-10

• Using the show diag (slot) Command, page 4-12

• Using the show interfaces Command, page 4-13

Choose the subsection appropriate for your system. Proceed to the “Using the ping Command to Verify

Network Connectivity” section on page 4-15 when you have finished using the show commands.

Table 4-7 Using show Commands

Command Function Example

show version Displays system Cisco IOS

software version, names and

sources of configuration files, and

boot images

Router# show version

show controllers Displays all the current E3

interfaces

Router# show controllers

show diag slot Displays types of line cards

installed in your system and

information about a specific

chassis slot

Router# show diag 2

show interfaces type slot-number/

interface-port-number

Displays status information about

a specific type of interface (for

example, serial) in a Cisco 7304

router

Router# show interfaces serial 2/0

show protocols Displays protocols configured for

the entire system and for specific

interfaces

Router# show protocols

show running-config Displays the running

configuration file

Router# show running-config

show startup-config Displays the configuration stored

in NVRAM

Router# show startup-config

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 53 54

Comentarios a estos manuales

Sin comentarios

Cisco 7300-6T3 Especificaciones Pagina 43

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco 7300-6T3