Cisco 7507 Manual de usuario descargar pdf (Pagina 32)

Install Field Replaceable Units (FRUs)

Step 8 If you have a VIP4 and are using HSA

with an RSP2 as the slave processor, wait

20-30 seconds, then reinsert the RSP2.

Step 9 Repeat Step 2 through Step 8 to remove

anyadditional interfaceprocessors,ﬁllers,

VIPs, or RSPs.

Step 10 Perform the steps in the “Install Interface

Processors, Fillers, VIPs, or RSPs” section

on page 10 to install an interface

processor, ﬁller, VIP, or RSP.

Check the RSP Installation

Step 1 Check the RSP connections to make sure

they are secure:

• The RSP is inserted all the way into its slot, and

both the captive installation screws are

tightened.

• The console terminal is turned on and is

connected to the console port.

Step 2 Observe the RSP LEDs. While the system

initializes, the CPU halt LED on the RSP

stayson. It goes off when the boot process

is complete. As the RSP initializes each

interface processor, the status LEDs on

each interface processor go on and off in

irregular sequence.

Step 3 Verify that the console terminal displays

the system banner and startup screen as

the system restarts.

Note Boot time is approximately 1 minute for

systems with one RSP and approximately 1.5

minutes for systems with two RSPs.

Step 4 Verify that all the enabled LEDs (on the

interface processors) are on.

Step 5 In systems with a second RSP installed

(and HSA or HA conﬁgured), use the

show version command to verify that the

slave (or standby) RSP is recognized by

the system.

Step 6 When you have veriﬁed all the conditions

in Step 1 through Step 4 (or Step 5 if you

have a second RSP installed and want to

use the HSA or HA features), the

installation is complete.

IfyoureplacedtheRSP and saved yourconﬁguration

ﬁleto aremote serverbefore doingso, proceed to the

“Retrieve the Conﬁguration File for RSPs” section

on page 35.

An error condition exists if no LEDs go on at power

up or after initialization, or if the boot error or CPU

halt LEDs go on and remain on. If this happens, see

AppendixAintheCisco 7500 SeriesInstallationand

Conﬁguration Guide.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comentarios a estos manuales

Sin comentarios

Cisco 7507 Manual de usuario Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco 7507