Cisco 7507 Manual de usuario descargar pdf (Pagina 8)

6

Secure the Spacers

Install the Hardware

53380

A

B

C

Step 1 Loosen the 10-32 x 5/8-inch LG Phillips

pan-head screw at the end of the ledge of

the right-side bracket. This screw is the

anchor for the spanner bar.

Step 2 Remove the tape that secures the spanner

bar on the left bracket, and swing the bar

down(seeA)over the anchorscrewonthe

opposite bracket.

Step 3 If the spanner bar does not reach the

opposite bracket, loosen the pan-head

screws to allow more play between the

brackets.

Step 4 RepeatStep 1 throughStep 3 tofasten the

remainingspannerbartoitsanchorscrew.

(See C.)

Step 5 Push the brackets as far apart as possible

before tightening the screws.

Step 6 Use a Number 2 Phillips screwdriver to

tighten the six pan-head screws that

secure the brackets to the rack-mounting

posts, and the two anchor screws that

secure the spanner bars. (See B.)

Step 7 Adjust the brackets if the distance

between them is less than 17.5 inches

(44.45 cm).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comentarios a estos manuales

Sin comentarios