!
>J!OM6(L5@!K519!*G@=875.67!A:C0"!F!"4#""#""#"4Q!:C0>!F!"4#""#""#""J!
!
^9*!OS0P!7@.%*!57!(='*()M!@'*(1*)!7.!K*!.6=M!56@=8)*!*G@=875.67N!
!
CAT6500(config)#ip dhcp excluded-address 10.11.11.1 10.11.11.9
CAT6500(config)#ip dhcp excluded-address 10.11.11.12 10.11.11.254
CAT6500#hw-module module 1 reset
Proceed with reload of module?[confirm]
% reset issued for module 1
CAT6500#
00:24:58: %C6KPWR-SP-4-DISABLED: power to module in slot 1 set off (Reset)
!
09*@U!19*!+P!())'*77*7!(&(56!(/1*'!19*!'*=.()N!
!
CAT6500#show wism status
Service Vlan : 11, Service IP Subnet : 10.11.11.254/255.255.255.0
WLAN
Slot Controller Service IP Management IP SW Version Status
----+-----------+----------------+----------------+-----------+---------------
1 1 10.11.11.10 169.254.1.1 4.2.207.0 Oper-Up
1 2 10.11.11.11 169.254.1.1 4.2.207.0 Oper-Up
!
RJ!OM6(L5@!K519!;D0!'*7*'?(15.67!A:C0"!F!"4#""#""#>4Q!:C0>!F!"4#""#""#>"J!
!
+6!.')* '!1. !U 6 . K!K9(1!19 * !;D0!())'*77*7!('*!./!19*!:C0!7*'?5@*!561*'/(@*7#!-.!K*!).!19*!
!
Welcome to the Cisco Wizard Configuration Tool
Use the '-' character to backup
System Name [Cisco_0a:45:ab]: WLC1
Enter Administrative User Name (24 characters max): admin
Enter Administrative Password (24 characters max): *****
Re-enter Administrative Password : *****
Service Interface IP Address Configuration [none][DHCP]:
Management Interface IP Address: 10.11.21.10
Management Interface Netmask: 255.255.255.0
Management Interface Default Router: 10.11.21.254
Management Interface VLAN Identifier (0 = untagged): 21
Management Interface DHCP Server IP Address: 10.11.21.254
AP Transport Mode [layer2][LAYER3]:
AP Manager Interface IP Address: 10.11.21.11
AP-Manager is on Management subnet, using same values
AP Manager Interface DHCP Server (10.11.21.254):
Virtual Gateway IP Address: 1.1.1.1
Mobility/RF Group Name: WiSM-WLC1
Enable Symmetric Mobility Tunneling [yes][NO]:
Network Name (SSID): WiSM-WLC1
Allow Static IP Addresses [YES][no]:
Configure a RADIUS Server now? [YES][no]: no
Warning! The default WLAN security policy requires a RADIUS server.
Please see documentation for more details.
Enter Country Code list (enter 'help' for a list of countries) [US]:
Enable 802.11b Network [YES][no]:
Enable 802.11a Network [YES][no]:
Enable 802.11g Network [YES][no]:
Comentarios a estos manuales