Cisco WS-SVC-WISM-1-K9 Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 22
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
!
CAT6500(config)#no ip dhcp pool WLC1
CAT6500(config)#no ip dhcp pool WLC2
!
-*1!19*!561*'/(@*7!56!19*!@.61'.==*'!1.!71(15@!(6)!7*1!19*!+P!())'*77!L(68(=N!
!
(WiSM-slot1-1) >config interface address service-port 10.11.11.30 255.255.255.0
The DHCP protocol for the service port must be disabled before configuring the IP addr
(WiSM-slot1-1) >config interface dhcp service-port disable
(WiSM-slot1-1) >config interface address service-port 10.11.11.30 255.255.255.0
!
B*'5/M!51N!
!
(WiSM-slot1-1) >show interface summary
Interface Name Port Vlan Id IP Address Type Ap Mgr Guest
-------------------------------- ---- -------- --------------- ------- ------ -----
ap-manager LAG 21 10.11.21.11 Static Yes No
management LAG 21 10.11.21.10 Static No No
service-port N/A N/A 10.11.11.30 Static No No
virtual N/A N/A 1.1.1.1 Static No No
!
O.!19*!7(L*!/.'!:C0>N!
!
(WiSM-slot1-2) >config interface address service-port 10.11.11.31 255.255.255.0
The DHCP protocol for the service port must be disabled before configuring the IP addr
(WiSM-slot1-2) >config interface dhcp service-port disable
(WiSM-slot1-2) >config interface address service-port 10.11.11.31 255.255.255.0
(WiSM-slot1-2) >show interface summary
Interface Name Port Vlan Id IP Address Type Ap Mgr Guest
-------------------------------- ---- -------- --------------- ------- ------ -----
ap-manager LAG 21 10.11.21.21 Static Yes No
management LAG 21 10.11.21.20 Static No No
service-port N/A N/A 10.11.11.31 Static No No
virtual N/A N/A 1.1.1.1 Static No No
!
R#!D@@*77!:C0"!(6)!:C0>!K519.81!8756&!1*=6*1Q!--S!.'!([email protected].=*[email protected]*@15.6#!
!
CAT6500#session slot 1 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 10.11.11.30 ... Open
(WiSM-slot1-1)
User:
CAT6500#session slot 1 processor 2
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 10.11.11.31 ... Open
Iwan Hoogendoorn
CCIE4 #13084
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Comentarios a estos manuales

Sin comentarios