Cisco Blower Module 10000 ESR Guía de instalación descargar pdf (Pagina 190)

17-28

Cisco 10000 Series Routers Line Card Hardware Installation Guide

OL-6773-04

Chapter 17 Installing and Removing Line Cards

Installing SFP Modules or GBIC Modules

Installing an SFP Module

This section describes the procedure to insert an SFP module into the Gigabit Ethernet half-height line

card.

Step 1 Attach an antistatic wrist strap to your wrist and to an ESD socket on the chassis, or to a bare metal

surface on the chassis or frame (Figure 17-24).

Figure 17-24 ESD Chassis Connection—Cisco 10008 Router

Step 2 Gently insert the SFP module into the line card port until the edge connector is fully seated in the

connector (Figure 17-25). As the triangular pin on the bottom of the SFP module snaps into place, you

hear a click.

1 ESD socket

PROCESSOR ONLY

POWER

FAULT

MISWIRE

CISCO

10000

PERFORMANCE ROUTING ENGINE

SLOT 0

STATUS

FAIL

BITS

P/N

ESR-PRE3

PERFORMANCE ROUTING ENGINE

SLOT 0

STATUS

FAIL

BITS

P/N

ESR-PRE3

CH OC-12-DSO SM-IR

6XCT3–DS0

FAIL

6XCT3–DS0

OC–12/STM–4 POS SM–IR

126144

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 253 254

Sin comentarios

Cisco Blower Module 10000 ESR Guía de instalación Pagina 190