Cisco Engine 611 Especificaciones Pagina 632

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 718
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 631
3-586
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
(config-if) encapsulation dot1Q
(config-if) encapsulation dot1Q
To set the VLAN ID that is to be assigned to traffic that leaves a WAE, use the encapsulation dot1Q
interface configuration command.
encapsulation dot1Q VLAN
Syntax Description
Defaults No default behavior or values.
Command Modes interface configuration
Device Modes application-accelerator
Usage Guidelines The encapsulation dot1Q command is available only for the inlineGroup interface.
Note If the VLAN ID that you set with the encapsulation dot1Q interface command does not match the
VLAN ID expected by the router subinterface, you may not be able to connect to the inline interface IP
address.
The inline adapter supports only a single VLAN ID for each inline group interface. If you have
configured a secondary address from a different subnet on an inline interface, you must have the same
secondary address assigned on the router subinterface for the VLAN.
Examples The following example shows how to set a VLAN ID to encapsulate traffic leaving the WAE:
(config)# interface inlineGroup 1/0
(config-if)# encapsulation dot1Q 100
Related Commands (config) interface GigabitEthernet
(config-if) ip
VLAN VLAN ID from 1–4094.
Vista de pagina 631
1 2 ... 627 628 629 630 631 632 633 634 635 636 637 ... 717 718

Comentarios a estos manuales

Sin comentarios