Cisco Engine 611 Especificaciones Pagina 682

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 718
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 681
3-636
Cisco Wide Area Application Services Command Reference
OL-16451-01
Chapter 3 CLI Commands
(config-preposition) dscp
(config-preposition) dscp
To set the DSCP marking value for a preposition task, use the dscp preposition configuration command.
To remove a DSCP marking value, use the no form of this command.
dscp value
no dscp value
Syntax Description
Defaults No default behavior or values.
Command Modes preposition configuration mode
Device Modes application-accelerator
Usage Guidelines This command specifies the DSCP marking value to be used for prepositioning traffic.
DSCP is a field in an IP packet that enables different levels of service to be assigned to the network
traffic. The levels of service are assigned by marking each packet on the network with a DSCP code and
associating a corresponding level of service. DSCP is the combination of IP Precedence and Type of
Service (ToS) fields. For more information, see RFC 2474.
For details on the valid DSCP marking values, see Table 3-119 on page -501.
Examples The following example shows how to set the DSCP marking value to cs7:
WAE(config)# accelerator cifs preposition 3
WAE(config-preposition)# dscp cs7
Related Commands (config) policy-engine application set-dscp
value DSCP marking value to assign to prepositioning traffic.
Vista de pagina 681
1 2 ... 677 678 679 680 681 682 683 684 685 686 687 ... 717 718

Comentarios a estos manuales

Sin comentarios