Cisco IE-3010-16S-8PC Guía de instalación descargar pdf (Pagina 21)

Cisco IE 3010 Switch Getting Started Guide

78-19582-02

Cisco IE 3010 Switch Getting Started Guide

DC power:

Insert the positive wire into the terminal

screw labeled +, and the negative wire into

the terminal screw labeled –.

Make sure that you cannot see any wire lead.

Only wire with insulation should extend from

the terminal screw.

Note If you have a low-voltage DC power

supply module, connect the wires to

the terminal screws labeled Lo. If you

have a high-voltage DC power supply

module connect the wires to the

terminal screws labeled Hi.

Step 9

Torque the captive screws (above the installed wire leads) to 8.5 in-lb (± 0.5 in-lb).

Step 10

AC power:

Connect the other end of the line wire (the one connected to L) to the line terminal on the

AC-power source, and connect the other end of the neutral wire (the one connected to N) to

the neutral terminal on the AC power source.

DC power:

Connect the other end of the positive wire (the one connected to +) to the positive terminal

on the DC power source, and connect the other end of the negative wire (the one connected

to –) to the negative terminal on the DC power source.

Step 11

When you are testing the switch, one power connection is sufficient. If you are installing the

switch and are using a second power source, repeat Step 3 through Step 10.

Step 12

Close the power-input terminal cover. Use a ratcheting torque screwdriver to torque the screw

to 6–8 in-lb.

Cisco IE 3010

208338

Cisco

IE 3

301

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Cisco IE-3010-16S-8PC Guía de instalación Pagina 21