Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Guía de instalación descargar pdf (Pagina 31)

1-5

Catalyst 3550 Multilayer Switch Hardware Installation Guide

78-11358-06

Chapter 1 Using Express Setup

Starting Express Setup

Express Setup provides the minimum configuration to configure a switch. You do

not create a username with Express Setup. To create a username for the switch,

use the Cluster Management Suite (CMS) or the command-line interface (CLI).

Note Before starting Express Setup, verify that the switch has passed POST and that the

system and status LEDs are green. For information about troubleshooting a POST

failure, see the “Understanding POST Results” section on page 4-1. You cannot

start Express Setup until POST has completed.

Caution Do not start Express Setup when there are any devices connected to the switch.

The switch acts as a DHCP server during the Express Setup procedure. Only the

PC or workstation connected to the switch after Express Startup is started should

receive a DHCP address from the switch.

Follow these steps to start the Express Setup program:

Step 1 Verify that no devices are connected to the switch.

Step 2 Press and hold the Mode button, as shown in Figure 1-4, until the LEDs above the

Mode button turn green. This takes approximately 2 seconds.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 175 176

Sin comentarios

Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Guía de instalación Pagina 31