Cisco WS-X6416-GE-MT - Interface Module - Expansion Guía de instalación descargar pdf (Pagina 142)

Chapter 3 Installing the Module

Installing a Supervisor Engine or a Switching Module

3-4

Catalyst 6500 Series Switch Module Installation Guide

78-15725-02

To install a supervisor engine or module in the chassis, follow these steps:

Step 1 Choose a slot for the supervisor engine or module.

Step 2 Verify that there is enough clearance to accommodate any interface equipment

that you will connect directly to the supervisor engine or module ports. If

possible, place modules between empty slots that contain only module filler

plates.

Step 3 Verify that the captive installation screws are tightened on all modules installed

in the chassis. This action assures that the EMI gaskets on all modules are fully

compressed in order to maximize the opening space for the new or replacement

module.

Note If the captive installation screws are loose, the EMI gaskets on the

installed modules will push adjacent modules toward the open slot,

reducing the opening size and making it difficult to install the

replacement module.

Step 4 Remove the module filler plate by removing the two Phillips pan-head screws

from the filler plate. To remove a module, refer to “Removing the Supervisor

Engine or a Switching Module” section on page 3-12.

Step 5 Fully open both ejector levers on the new or replacement module. (See

Figure 3-1.)

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 193 194

Sin comentarios

Cisco WS-X6416-GE-MT - Interface Module - Expansion Guía de instalación Pagina 142