Cisco 828 - 828 Router - EN Guía de instalación descargar pdf (Pagina 44)

Chapter 3 Troubleshooting

Problems After Router Is Running

3-4

Cisco 828 Router and SOHO 78 Router Hardware Installation Guide

78-12837-02

Problems After Router Is Running

Table 3-2 lists problems that could occur after the router has been up and running.

Table 3-2 Problems After Router Is Running

Symptom Problem Solutions

Problems with the Ethernet

connection. (Ethernet LED is

off.)

A cable-related

problem:

• Disconnected

cable.

• Damaged cable.

Perform the following steps:

1. Make sure that the connectors at both

ends of the cable are secure.

2. Make sure that the cable is not

physically damaged. If it is damaged,

order another cable from Cisco

Systems, or replace it with a similar

cable.

Connection to the G.SHDSL

line is intermittent or lost.

(The CD LED on the front

panel is off.)

A cable-related

problem:

• Disconnected

cable.

• Damaged cable.

Perform the following steps:

1. Make sure that the connectors at both

ends of the cable are secure.

2. Make sure that the cable is not

physically damaged. If it is damaged,

order another cable from Cisco

Systems, or replace it with a similar

cable.

Problem with G.SHDSL

line or WAN service.

Contact your G.SHDSL line or WAN

service provider to determine whether there

is a problem.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 57 58

Comentarios a estos manuales

Sin comentarios

Cisco 828 - 828 Router - EN Guía de instalación Pagina 44

Comentarios a estos manuales

Relacionado con productos y manuales para Routers Cisco 828 - 828 Router - EN