Cisco 6200 Guía de usuario descargar pdf (Pagina 9)

APRIL 2008

LINK AGGREGATION INTEROPERABILITY OF THE DELL POWERCONNECT 6200 SERIES SWITCH

CONFIGURING THE 6200 SERIES PORTS FOR STATIC LINK AGGREGATION

The following example shows the PowerConnect 6200 Series Gigabit Ethernet switch CLI

commands for configuring three ports of the Gigabit Ethernet switch for static aggregation.

Note that a LAG can be configured with 0-6 ports (the example uses 3), and a port may only be

part of a single LAG:

PC6248(config)# interface range ethernet 1/g17-1/g19

PC6248(config-if)# channel-group 1 mode on

COMMAND DESCRIPTION

interface range ethernet 1/g17-1/g19

Sets the CLI mode to configure three Gigabit Ethernet ports

(1/g17, 1/g/18, and 1/g19).

channel-group 1 mode on

Aggregates the three ports into a static LAG. Static LAGs do not

use LACP and are defined in the CLI by setting the channel-

group mode to mode on. The ‘1’ for the channel-group number

only has meaning within the switch and is used to differentiate

up to 18 unique channel-groups. For each LAG created, you will

need to choose a number from 1-18, for up to the maximum of

18 groups. The internal ports that connect to the servers do not

support link aggregation groups.

To assign ports 1/g17 through 1/g19 to LAG 1 by using the Web interface, navigate to the

Switching > Link Aggregation > LAG Membership page.

In the Ports area, click the button under ports 1/g17 through 1/g19 in the LAG row. The

number 1 appears to indicate that the port belongs to LAG 1. Make sure the LACP option for

the ports is clear. Click Apply Changes to save the settings to the running configuration.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Cisco 6200 Guía de usuario Pagina 9