Cisco 15454-TCC - Network Processor Card Especificaciones Pagina 165

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 334
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 164
3-9
Cisco ONS 15454 Troubleshooting and Maintenance Guide
November 2001
Chapter 3 Maintenance
System Reset
Figure 3-5 Performing a software-initiated reset from the TCC+ card pull-down menu
Procedure: Perform a Card Pull
Note To determine whether you have an active or standby TCC+, position the cursor over the TCC+ card
graphic to display the status.
Step 1 If you need to perform a card pull on an active TCC+ card, first perform a software-initiated reset on the
active TCC+ (see the Perform a Software-Initiated Reset procedure on page 3-8).
Step 2 When the TCC+ is in standby mode, unlatch both the top and bottom ejector levers on the TCC+ card.
Step 3 Physically pull the card at least partly out of the slot until the lighted LEDs turn off.
Step 4 Wait 30 seconds. Reinsert the card and close the ejector levers.
Note The TCC+ will take several minutes to reboot and will display the amber standby LED after
rebooting.
Vista de pagina 164
1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 333 334

Comentarios a estos manuales

Sin comentarios