Cisco Prisma II Hybrid Amplifier Información técnica descargar pdf (Pagina 11)

External Alarms Connections

Master/Slave Operation

 All Prisma II modules ship from the factory configured as a master. The

LCI, TNCS software, or the ICIM can be used to reconfigure a module as

a slave or as redundant (slave).

 The Chassis allows for local hard-wired redundancy by using the ALARM

IN and ALARM OUT connectors. A pair of modules can be configured so

that if the master fails, the slave takes over by using the ALARM IN and

ALARM OUT connectors

ALARM IN and ALARM OUT Connectors

 The Prisma II Chassis provides two connectors for external alarms to and

from each module slot. These alarm connectors are located in two 37-pin

D-connectors (DB-37) and are labeled ALARM IN and ALARM OUT.

• NOTE: Master Slave feature requires Redundancy Interface Panel (RIP). The RIP serves

as an extension to the two DB-37 connectors labeled ALARM IN and ALARM OUT – see

IO Guide for further details

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 123 124

Sin comentarios

Cisco Prisma II Hybrid Amplifier Información técnica Pagina 11