Cisco 3520 Guía de instalación descargar pdf (Pagina 25)

Release Notes for the Catalyst 3750 Switch Cisco IOS Release 12.1(14)EA1

OL-4215-01

Open Caveats

• CSCeb66720

When CDP is disabled on a stack member interface and that interface is converted to a routed port

or switch port, CDP is re-enabled on the stack member interfaces. Having CDP enabled on a stack

member but not on the stack master can cause the 802.1X voice VLAN and inline power features to

fail on the stack member.

The workaround is to enable and then disable CDP on the interface.

• CSCeb69078

Executing remote commands on a Catalyst 3750-12S switch that is unpacking and copying a new

software image to Flash memory can cause the software upgrade to fail.

The workaround is to reload the switch to re-enable Flash operations, and then repeat the software

upgrade procedure.

Open CMS Caveats

These are the severity 3 CMS configuration caveats:

• CSCdz01037

CMS fails when a switch is running the crypto software image and the vty lines have been

configured to use only secure shell (SSH) using the transport input ssh and line vty 0 15 global

configuration commands.

The workaround is to allow SSH and Telnet access through the vty lines by using the transport

input ssh telnet and line vty 0 15 global configuration commands.

• CSCeb05183

The Port Settings table displays meaningless information in the columns for interface description

and duplex cells. This problem occurs for some of the Catalyst 2820 and Catalyst 1900 switches.

There is now workaround.

• CSCeb23334

CMS does not validate configuration values for STP port priority before applying them to the switch.

When invalid values are applied, the attempt fails silently without a warning message. This applies

to all switches running Cisco IOS Release 12.1 or later.

There is no workaround. Make sure that configuration values are valid.

• CSCeb23416

CMS does not validate configuration values for STP port path cost before applying them to the

switch. When invalid values are applied, the attempt fails silently without a warning message. This

applies to all switches running Cisco IOS Release 12.1 or later.

There is no workaround. Make sure that configuration values are valid for the switch type.

• CSCeb23592

CMS does not validate configuration values for STP bridge parameters before applying them to the

switch. When invalid values are applied, the attempt fails silently without a warning message. This

applies to all switches running Cisco IOS 12.1 or later.

There is no workaround. Make sure that configuration values are valid.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 33 34

Sin comentarios

Cisco 3520 Guía de instalación Pagina 25