
26
Release Notes for the Catalyst 3750 Switch Cisco IOS Release 12.1(14)EA1
OL-4215-01
Resolved Caveats
• CSCeb25630
The Link Graphs bar chart for Packet Drops & Errors might display erroneous errors for Ethernet
interfaces.
The workaround is to use the show interfaces or show interfaces counter privileged EXEC
commands command.
• CSCeb38514
Sometimes a switch stack icon disappears from the topology view. This can occur if one of the
switch stack members goes down or a switch stack member is disconnected from the stack.
The workaround is to close the CMS browser and launch CMS again.
• CSCeb38967 LOTR and TRS
When CMS is operating in read-only mode, an error is reported if help is launched from the QoS
Graph dialog box.
There is no workaround.
• CSCeb40625
CMS does not apply shaped bandwidth weights that are invalid. Shaped weights are invalid if the
sum of their reciprocals is greater than 1 and the weight of a queue is 0.
There is no workaround.
Resolved Caveats
These are the caveats that have been resolved in this release.
• “Cisco IOS Caveats Resolved in Release 12.1(14)EA1” section on page 26
• “Cisco CMS Caveats Resolved in Release 12.1(14)EA1” section on page 29
Cisco IOS Caveats Resolved in Release 12.1(14)EA1
These Cisco IOS caveats were resolved in Release 12.1(14)EA1:
• CSCdy29217
After the stack master failover and when the previous stack master rejoins the stack, some Layer 3
configuration on routed port interfaces belonging to the previous stack master are no longer lost (for
example, the IP address, bridge groups, and so forth). This problem previously occurred under these
conditions:
–
When the configuration of the switch stack has been modified but not saved.
–
The stack master fails, and a new switch in the switch stack is elected to become the new stack
master.
–
The previous stack master rejoins the switch stack.
–
There is at least one port on the previous stack master physically configured as a routed port
with some Layer 3 configuration.
Comentarios a estos manuales