Cisco 7200 VXR Manual de usuario descargar pdf (Pagina 18)

4 Connect the Router to the Network

Figure 13 Connecting the Console and Auxiliary Port Cables

I/O Controller and NPE-G1 or NPE-G2 Console and Auxiliary Port Cable Connections

Note Both the console and auxiliary ports are asynchronous serial ports; any devices connected to these ports must be capable

of asynchronous transmission.

Step 1 Before connecting a terminal to the console port, configure the terminal to match the router console port as follows:

9600 baud, 8 data bits, no parity, 2 stop bits (9600 8N2).

Step 2 Use an EIA/TIA-232 DCE console cable to connect the terminal to the console port. After you establish normal router

operation, you can disconnect the terminal.

Note You must supply your own interface cable between the auxiliary port and the equipment you are connecting.

For console and auxiliary port pinouts, see the online Cisco 7200 VXR Installation and Configuration Guide,

Chapter 3, “Console Port Signals and Auxiliary Port Signals.”

Note When connecting to an auxiliary port on a Cisco 7200 VXR router, the port will not function at baud rates

higher than 19.2kb. If the baud rate on the connecting device is set higher than 19.2kb, garbled text or nothing

will be displayed on the screen.

Auxiliary port-DTE-mode; EIA/TIA-232, DTE-DB-25

connector (for modem, CSU/DSU, and so on.)

Modem

Console port-DCE-mode; EIA/TIA-232, DCE-DB-25

connector (for data terminal)

Console terminal

57007

MII

RJ45

LINK

1O PWR

RJ-45

CPU RESET

FAST ETHERNET INPUT/OUTPUT CONTROLLER

ENABLED

PCMCIA

EJECT

SLOT 0

SLOT 1

FE MII

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sin comentarios

Cisco 7200 VXR Manual de usuario Pagina 18