Cisco 7200 VXR Manual de usuario descargar pdf (Pagina 6)

2 Prepare for Installation

Warning

Only trained and qualified personnel should install, replace, or service this equipment.

Statement 1030

Warning

Read the installation instructions before you connect the system to its power source.

Statement 10

Warning

This unit is intended for installation in restricted access areas. A restricted access area is where access can only

be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is

controlled by the authority responsible for the location.

Statement 37

Before beginning this router installation read the Regulatory Safety and Compliance Information for Cisco 7200 Series Routers

document including the section “Site Preparation and Safety Information.”

Site Preparation and Unpacking

• Lift the router safely out of the packing container.

• Ensure the power service at the site is suitable for the router you are installing.

• Check the packing slip to ensure that all the proper components are present.

• Locate and have accessible the Site Log for recording information about this installation.

Tools and Parts

Part Part

• Grounding lug and wires: • Power cord

–

A grounding lug with two number-10 screw holes with a 0.63-inch

(16.002-mm) spacing between them

• Appropriate cables to connect the router to

the network and console terminal

–

A wire receptacle large enough to accept a 6-AWG multistrand,

copper wire

• Level

–

Two Phillips machine screws with locking washers—M5 (metric),

0.031-inch (.08-mm) pitch, 0.315-inch (8-mm) length

• Data service unit (DSU) to connect each

serial port to an external network

–

A crimping tool to fit the grounding lug wire receptacle • Tape measure

–

One grounding wire—6-AWG, 0.162-inch (4.115-mm) diameter,

with approximately 0.108-inch (2.743-mm) insulation, for a total

wire diameter of approximately 0.27 inches (6.858 mm). The wire

length depends on your router location and site environment.

• One serial port adapter cable for each serial

port to connect the port with the remote

device or network Ethernet transceiver

• The rack-mount and cable-management kit: • Number 2 Phillips screwdriver

–

Two rack-mount brackets and two cable-management brackets • 3/16-inch flat-blade screwdriver

–

Four M4 x 8-mm Phillips flathead screws • Wire stripper

–

Six 10-32 x 3/8-inch slotted binderhead screws • ESD-preventative wrist strap

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Comentarios a estos manuales

Sin comentarios

Cisco 7200 VXR Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Cisco 7200 VXR