Cisco XR 12000 Series Manual de usuario Pagina 115
- Pagina / 148
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
2-85
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
OL-17438-04
Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters
1-Port 10-Gigabit Ethernet WAN PHY SPA Overview
Cisco Systems qualifies the optics that are approved for use with its SPAs.
As of Cisco IOS Release 12.0(31)S, the above listed XFPs are the only optical transceiver modules
qualified for use.Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns
(nominal diameter is approximately 10/125 microns) to connect your router to a network.
The 1-Port 10-Gigabit Ethernet DWDM SPA has an in-built XFP optical transceiver module, and so, an
external XFP module is not required.
This figure shows the cable type for use with the XFP optical transceiver module on the 1-Port
10-Gigabit Ethernet SPA.
Figure 2-62 LC-Type Cable for the XFP Optical Transceiver Modules
Note The 40-pin connector on the 1-Port 10-Gigabit Ethernet SPA is used for resilient packet ring (RPR)
connections.
1-Port 10-Gigabit Ethernet WAN PHY SPA Overview
The 1-Port 10-Gigabit Ethernet SPA is a single-height SPA that installs into one SIP subslot. There are
two types of 1-Port 10-Gigabit Ethernet SPA: the SPA-1X10GE-L-V2 and the SPA-1X10GE-WL-V2.
The SPA-1X10GE-L-V2 supports the 10-Gigabit Ethernet LAN physical layer device (PHY) mode of
operation at an optical interface bit rate of 10.3125
Gbps. The SPA-1X10GE-WL-V2 supports both the
10-Gigabit Ethernet LAN PHY mode of operation (at 10.3125
Gbps) as well as the 10-Gigabit Ethernet
WAN PHY mode of operation (at 9.95328
Gbps). The following sections describe the 1-Port 10-Gigabit
Ethernet SPA.
• 1-Port 10-Gigabit Ethernet SPA LEDs, page 2-85
• 1-Port 10-Gigabit Ethernet SPA XFP Optical Transceiver Modules, Connectors, and Cables,
page 2-86
1-Port 10-Gigabit Ethernet SPA LEDs
The 1-Port 10-Gigabit Ethernet SPA has two LEDs, as shown in Figure 2-63.
/ / / /
/ /
TXRX
84929
- Hardware Installation Guide 1
- CONTENTS 3
- Contents 4
- Changes to This Document 9
- OL-17438-04 10
- Objectives 11
- Organization 11
- Related Documentation 12
- Interface Processors 13
- Router Hardware Installation 14
- Supported Platforms 15
- SIP Summary 16
- Cisco XR 12000 SIP-600 LEDs 18
- Cisco XR 12000 SIP-401 LEDs 21
- Cisco XR 12000 SIP-501 LEDs 24
- 10-Port Gigabit Ethernet SPA 26
- Cisco XR 12000 SIP-601 LEDs 27
- Port Adapters 31
- SPA Summary 32
- Bandwidth Oversubscription 33
- Bandwidth Oversubscription 34
- Figure 2-4 RJ-45 Connector 40
- 8-Port FastEthernet SPA LEDs 41
- RJ-45 connector 42
- XFP Connections 45
- SPA-2X1GE 47
- SPA-2X1GE-V2 48
- SFP Module Connections 49
- SFP-GE-S Modules 51
- SFP-GE-L Modules 51
- SFP-GE-Z Modules 51
- SFP-GE-T Modules 51
- SPA-1XCHSTM1/OC3 60
- Figure 2-18 SFP Optics Module 62
- Figure 2-19 LC Type Cables 62
- Figure 2-21 SFP Optics Module 64
- Figure 2-24 SFP Optics Module 67
- Figure 2-25 LC Type Cables 67
- Connector, and Cables 70
- Figure 2-28 SPA Mate Cables 71
- OC-192 Module Connections 74
- Mate Interface Cables 75
- Figure 2-33 SFP Optics Module 78
- Figure 2-34 LC-Type Cable 78
- OC-3 Module Connections 79
- SPA-8XOC12-POS 80
- OC-12 Module Connections 84
- SPA-1XOC12-POS 85
- Figure 2-40 LC-Type Cable 88
- Figure 2-43 SPA Mate Cables 91
- SPA-2XOC48-POS/RPR 92
- Modules, and Connectors 93
- OC-48 Module Connections 94
- 2-Port OC48-POS/RPR SPA LEDs 95
- Connectors 97
- IPSec VPN SPA LEDs 98
- Figure 2-51 SFP Optics Module 100
- Figure 2-54 SFP Optics Module 103
- SPA-2CHT3-CE-ATM 104
- Cable Installation 108
- SPA Cable Pinouts 108
- RJ-45 Cable Pinouts 111
- Patch Panel Cabling 111
- Connectors, and Cables 114
- ACTIVE/LINK 116
- XFP Module Connections 117
- SPA Interface Processor 119
- Telephone Wiring Guidelines 120
- Laser/LED Safety 120
- Required Tools and Equipment 122
- Processor 123
- Removing and Installing a SIP 124
- Removing a SIP 125
- Installing a SIP 127
- Handling SPAs 129
- Online Insertion and Removal 130
- SPA Installation and Removal 130
- Cleaning Optical Devices 131
- Checking the Installation 132
- Checking the Installation 133
- Troubleshooting the SIP 137
- Using debug Commands 137
- Packing a SIP for Shipment 138
- Packing a SPA for Shipment 139
- Packing a SPA for Shipment 140
- GLOSSARY 141
- Glossary 142
- Numerics 143
Relacionado con productos y manuales para Hardware Cisco XR 12000 Series
Hardware Cisco 15310-MA Manual de usuario
(10 paginas)
(10 paginas)
Hardware Cisco 7100 Series Manual de usuario
(24 paginas)
(24 paginas)
Hardware Cisco 12012 Manual de usuario
(34 paginas)
(34 paginas)
Hardware Cisco 2600 Manual de usuario
(32 paginas)
(32 paginas)
Hardware Cisco 3725 Manual de usuario
(22 paginas)
(22 paginas)
Hardware Cisco WRT320N Manual de usuario
(53 paginas)
(53 paginas)
Hardware Cisco 7200 VXR Manual de usuario
(64 paginas)
(64 paginas)
Hardware Cisco 1600 Manual de usuario
(13 paginas)
(13 paginas)
Hardware Cisco 12406 Manual de usuario
(36 paginas)
(36 paginas)
Hardware Cisco WES610N Manual de usuario
(546 paginas)
(546 paginas)
Hardware Cisco 3500 Series Manual de usuario
(8 paginas)
(8 paginas)
Hardware Cisco 1005 Manual de usuario
(6 paginas)
(6 paginas)
Hardware Cisco 2600 Series Manual de usuario
(10 paginas)
(10 paginas)
Hardware Cisco 1720 Manual de usuario
(12 paginas)
(12 paginas)
Hardware Cisco 3660 Manual de usuario
(10 paginas)
(10 paginas)
Hardware Cisco 32369 Manual de usuario
(52 paginas)
(52 paginas)
Hardware Cisco (VIP6-80) Manual de usuario
(40 paginas)
(40 paginas)
Hardware Cisco ASA 5505 Manual de usuario
(199 paginas)
(199 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.053 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales