Cisco XR 12404 Manual de usuario Pagina 133

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 178
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 132
5-9
Cisco XR 12404 Router Installation Guide
OL-13830-02
Chapter 5 Maintaining the Router
Removing and Replacing the Air Filter
Use the following procedure to clean or replace the air filters.
Step 1 Grasp the small tab on the edge of the air filter and pull the tab to remove the air
filter from the chassis (Figure 5-5).
Tip If you are unable to lift the tab on the edge of the air filter, use a flat-blade
screwdriver to lift the tab, then grasp it.
Figure 5-5 Cisco XR 12404 Router Air Filter Location
Step 2
Visually check the condition of the air filter.
If the filter appears dirty, you can either vacuum or replace it.
Caution Do not vacuum the air filter while it is installed in the housing.
If the filter appears worn or torn, dispose of it in a responsible manner and
install a replacement air filter.
66278
INPUT
OK
OUTPUT
FAIL
INPUT
100-240V
12A
50/80H
Z
OUTPUT
OK
INPUT
OK
OUTPUT
FAIL
INPUT
100-240V
12A
50/80HZ
OUTPUT
OK
todd.book Page 9 Monday, March 16, 2009 2:47 PM
Vista de pagina 132
1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 177 178

Comentarios a estos manuales

Sin comentarios