Cisco XR 12410 Manual de usuario Pagina 182

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 238
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 181
Chapter 5 Maintaining the Router
Removing and Replacing the Blower Module
5-10
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Step 2 Install the new blower module into the chassis (Figure 5-6):
a. Lift the blower module (with two hands) and slide it halfway into the module
bay.
b. Slowly push the blower module into the chassis until it mates with the
backplane connector at the back of the module bay.
Caution To prevent damage to the connectors, do not use excessive force when inserting
the blower module into the chassis.
c. Tighten the captive screws on the blower module to secure it to the chassis.
The (green) OK status indicator on the front of the blower module goes on. If
the OK indicator does not light, see the
“Troubleshooting the Blower Module
Installation” section on page 5-11.
Figure 5-6 Installing the Blower Module
122100
A
C
T
0
DOWN
LOOP RA LA
CDHNT CD
TX
0
RX
TX
1
RX
DOWN
LOOP RA LA
CDHNT CD
TX
0
RX
TX
1
Vista de pagina 181
1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 237 238

Comentarios a estos manuales

Sin comentarios