Cisco 194424 - Interface Module ISDN-BRI Manual de usuario descargar pdf (Pagina 6)

Configure POTS Dial Peers for ISDN BRI Voice Ports

MOD-6

Release 12.0(4) T

ISDN BRI2 interface

Total Allocated ISDN CCBs = 0

Conﬁgure POTS Dial Peers for ISDN BRI Voice Ports

Conﬁguring POTS dial peers for ISDN BRI voice ports is similar to the POTS dial peer conﬁguration

for analog and digital voice ports. This section describes how to conﬁgure POTS dial peers

speciﬁcally for ISDN BRI voice ports.

To conﬁgure a POTS dial peer, you need to uniquely identify the dial peer (by assigning it a unique

tag number), deﬁne its telephone number, and associate it with a voice port. Under most

circumstances, the default values for the remaining dial-peer conﬁguration commands are sufﬁcient

to establish connections.

For more information about dial plan strategies, see the “Voice Dial Plan Considerations” chapter of

the Cisco MC3810 Multiservice Access Concentrator Software Conﬁguration Guide.

Note Only one dial peer is required for each BRI port, and a B channel is selected automatically.

For example, you conﬁgure one dial peer for BRI voice port 1/1, and it directs calls for BRI voice

ports 1/1 and 1/2.

Note You must conﬁgure the POTS dial peers on the routers at both ends of the network.

To conﬁgure POTS dial peers, follow these steps:

Step Command Purpose

1 conﬁgure terminal Enter global conﬁguration mode.

2 dial-peer voice tag pots Deﬁne a POTS peer and enter dial-peer conﬁguration mode. All

subsequent commands that you enter in dial-peer conﬁguration

mode before you exit will apply to this dial peer.

The tag value identiﬁes the dial peer and must be unique on the

Cisco MC3810. Do not duplicate a speciﬁc tag number.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Sin comentarios

Cisco 194424 - Interface Module ISDN-BRI Manual de usuario Pagina 6