Cisco 194424 - Interface Module ISDN-BRI Manual de usuario descargar pdf (Pagina 8)

Configuring Network-Side Dial Peers for ISDN BRI Voice Ports

MOD-8

Release 12.0(4) T

• The following is sample output from the show dial-peer voice summary command for a BRI

voice dial peer on the Cisco MC3810:

router# show dial-peer voice summary

TAG TYPE ADMIN OPER PREFIX DEST-PATTERN FWD PREF SESS-TARGET PORT

1 pots up down 2... 0 0

3 pots up down 3... 0 0

2 pots up down 1... 0 0

100 vofr up down 0 0

To conﬁgure network-side dial peers, see the next section “Conﬁguring Network-Side Dial Peers for

ISDN BRI Voice Ports.”

Conﬁguring Network-Side Dial Peers for ISDN BRI Voice Ports

The procedure for conﬁguring the network-side dial peers depends on the type of WAN transport

between this Cisco MC3810 and the far-end router or concentrator. See the appropriate procedure in

the Cisco MC3810 Multiservice Access Concentrator Software Conﬁguration Guide as follows:

• Voice over Frame Relay (VoFR)—“Conﬁguring Voice over Frame Relay Dial Peers” section in

the “Conﬁguring Voice over Frame Relay” chapter

• Voice over ATM (VoATM)—“Conﬁguring Voice over ATM Dial Peers” section in the

“Conﬁguring Voice over ATM” chapter

• Voice over HDLC (VoHDLC)—“Conﬁguring VoHDLC Dial Peers” section in the “Conﬁguring

Voice over HDLC” chapter

Make sure the voice port, serial port and/or the T1/E1 controller are set to no shutdown.

Note You must conﬁgure the network-side dial-peers on the router or Cisco MC3810 concentrator

at each end of the network.

Verify

Verify the network-side dial peer conﬁguration by following the verify procedure that accompanies

the conﬁguration procedure you used.

Conﬁguration Examples

This section contains the following conﬁguration examples:

• Conﬁguring an ISDN BRI voice port

• Conﬁguring a POTS dial peer for an ISDN BRI voice port

To view conﬁguration examples for network-side dial peers, see the conﬁguration procedure you

used (VoFR, VoATM, or VoHDLC).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sin comentarios

Cisco 194424 - Interface Module ISDN-BRI Manual de usuario Pagina 8