Verify
ISDN BRI Voice on the Cisco MC3810 MOD-7
Verify
Make sure the voice port, serial port and/or the T1/E1 controller are set to no shutdown.
Verify the POTS dial peer configuration by using the show dial-peer voice number or the
show dial-peer voice summary command.
• The following is sample output from the show dial-peer voice number command for a BRI voice
dial peer on the Cisco MC3810:
router# show dial-peer voice 1
VoiceEncapPeer1
tag = 1, destination-pattern = `2...',preference = 0,
Admin state is up, Operation state is down
DTMF Relay = disabled
type = pots, prefix = `', fwd-digits = 0,
session-target = `', voice-port =
3
destination-pattern string Configure the dial peer’s destination pattern.
The string variable is a series of digits that specify the E.164 or
private dialing plan telephone number. Valid values are digits from 0
to 9 and letters from A to D. The following special characters can be
entered in the string:
• The star character (*) and the pound sign (#) that appear on
standard touch-tone dial pads can be used in any dial string.
However, these characters cannot be used as leading characters in
a string (for example, *650).
• The period (.) can be entered any time, and is used as a wildcard
character.
• The comma (,) can be used only in prefixes, and is used to insert a
one-second pause or a delay.
Note The plus symbol (+) is not a valid character in the string.
4 port slot/port Associate this voice-telephony dial peer with a specific logical dial
interface. Enter the slot/port number of the voice port connected to
the POTS dial peer.
Note The slot/port syntax for BRI voice ports is different than for
standard analog or digital voice ports on the Cisco MC3810. For a
BRI voice port, the slot number is 1, 2, 3, or 4 to match the BRI voice
port being configured, and the port number is always 1.
5 num-exp extension-number
extension-string
(Optional) If using the number expansion feature, define how to
expand an extension number into a particular destination pattern.
6 prefix string (Optional) Assign the dialed digits prefix for the dial peer.
7 preference value (Optional) Configure a preference for the POTS dial peer. The value
is a number from 0 to 10 where the lower the number, the higher the
preference. If POTS and voice-network (VoFR) peers are mixed in
the same hunt group, POTS dial peers will be searched first, even if a
voice-network peer has a higher preference number.
For more information about hunt groups and preferences, see the
“Hunt Groups and Preference Configuration” section of the
Cisco MC3810 Multiservice Access Concentrator Software
Configuration Guide.
8 Exit from dial-peer configuration mode and repeat Steps 2 through 7 for the next dial peer.
Step Command Purpose
(378 paginas)
(298 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales