Cisco 1600R Guía de instalación descargar pdf (Pagina 51)

Troubleshooting A-3

Recovering a Lost Enable Password

Step 7 Do one of the following:

• If break is enabled, go to Step 8.

• If break is disabled, turn the router OFF, wait 5 seconds, and turn it ON again.

Within 60 seconds, press the Break key. The terminal displays the

ROM monitor prompt. Go to Step 9.

Note Some terminal keyboards have a key labeled Break. If your keyboard does not have

a Break key, refer to the documentation that came with the terminal for instructions on how

to send a break.

Step 8 Send a break. The terminal displays the following prompt:

rommon 2>

Step 9 Enter confreg 0x142 as follows to reset the conﬁguration register:

rommon 2> confreg 0x142

Step 10 Initialize the router by entering the initialize command:

rommon 2> initialize

The router cycles its power, and the conﬁguration register is set to 0x142. The

router uses the boot ROM system image, indicated by the system conﬁguration

dialog:

--- System Configuration Dialog ---

Step 11 Enter no in response to the prompts until the following message is displayed:

Press RETURN to get started!

Step 12 Press Return. The following prompt appears:

Router>

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 87 88

Sin comentarios

Cisco 1600R Guía de instalación Pagina 51