Cisco 2514 - Router - EN Manual de usuario Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 11
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
CONFIGURATION OF PCS AND ROUTERS - PAGE 2
Installing RedHat9.0
The following are instructions for the installation of RedHat 9.0 and the configuration of
software for the PCs in the Internet Lab. The Internet Lab should work with different Linux
distributions (Debian, SuSE, Slackware), but has been tested only for RedHat Linux.
If you already have RedHat 9.0 installed on your system, proceed to the next section
(“Installing Software Packages for the Internet Lab”). The instructions in this section are
minimal. If you have not installed an operating system before, you may want to seek the help
of a system administrator.
If you require more extensive information on installing and running Linux, we
recommend the following source:
Running Linux, Fourth Edition, by Matt Welsh, Lar Kaufman, Matthias K. Dalheimer,
Terry Dawson, O'Reilly & Associates. 4th edition, 2002
A good source for detailed, and more basic, information on installing RedHat Linux is
the following book:
Learning Red Hat Linux, 2nd Edition. A Guide to Red Hat Linux for New Users, by Bill
McCarty, 2nd Edition January 2002
For information on Linux that covers multiple distributions, we recommend:
Linux Administration Handbook. Evi Nemeth, Garth Snyder, Trent R. Hein, Adam
Boggs, Prentice Hall, 2002.
In addition, the Redhat website has a substantial amount of information:
http://www.redhat.com/docs/manuals/linux
The PCs should satisfy the following minimum system requirements:
300 Mhz Intel-compatible PC (recommended: 1Ghz)
64 MB RAM (recommended: 256 MB)
1 CD Rom drive
10 GB hard disk
1 floppy drive
2 Ethernet cards
1 DB9 serial port
a Linux compatible Video card
mouse and keyboard with PS/2 connectors.
Step 1: Preparing RedHat 9.0 Software.
If you have RedHat 9.0 CDs or have already downloaded a CD-ROM distribution
(three CDs) for RedHat 9.0, skip this step and proceed to Step 2.
Vista de pagina 1
1 2 3 4 5 6 7 ... 10 11

Comentarios a estos manuales

Sin comentarios