Cisco 3620 Especificaciones descargar pdf (Pagina 19)

Cisco 3600 Series Power Supply Configuration Note 19

Replacing Connections to the Router

Figure 21 Cisco 3640 DC-Input Power Supply Connections

Step 3

Turn ON the power switch. The power LED on the front panel of the router should go

ON.)

Step 4 Verify that the OK LED on the right side of the front panel goes ON after a few seconds’

delay when booting. If you have problems, see the next section, “Troubleshooting,” and

the section “Obtaining Service and Support” later in this document.

Warning Secure all power cabling when installing this unit to avoid disturbing ﬁeld-wiring

connections. (To see translated versions of this warning, refer to the Regulatory Compliance and

Safety Information document that accompanied the router.)

Warning This equipment is intended to be grounded. Ensure that the host is connected to earth

ground during normal use. (To see translated versions of this warning, refer to the Regulatory

Compliance and Safety Information document that accompanied the router.)

Terminal block

H7253

Positive

Negative

Ground

Terminal block

On/off

1 2 ... 14 15 16 17 18 19 20 21 22

Sin comentarios

Cisco 3620 Especificaciones Pagina 19