Cisco 7300-6T3 Especificaciones descargar pdf (Pagina 44)

4-8

OC12 Packet Over SONET Line Card Installation and Configuration

OL-3437-01

Chapter4 Configuring the OC12 POS Line Card

Checking the Configuration

If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is

not functioning properly, ensure that the interface is properly connected and terminated. If you still have

problems bringing up the interface, contact a service representative for assistance. This section includes

the following subsections:

• Using the show version or show hardware Commands, page 4-8

• Using the show diag Command, page 4-9

• Using the show c7300 Command, page 4-10

• Using the show interfaces Command, page 4-10

Choose the subsection appropriate for your system. Proceed to the “Using the ping Command to Verify

Network Connectivity” section on page 4-11 when you have finished using the show commands.

Using the show version or show hardware Commands

Display the configuration of the system hardware, the number of each interface type installed, the Cisco

IOS software version, the names and sources of configuration files, and the boot images by using the

show version (or show hardware) command.

Note The outputs that appear in this document may not match the output you receive when running these

commands. The outputs in this document are examples only.

Cisco 7304 Router

Following is an example of the show version command from a Cisco 7304 router with the OC12 POS

line card:

Router# show version

Cisco Internetwork Operating System Software

IOS (tm) 7300 Software (C7300-JS-M), Version 12.1(10),

Compiled Thu 29-Nov-01 04:27 by

Image text-base:0x40008970, data-base:0x417EE000

ROM:System Bootstrap, Version 12.1(20010827:230108) [hih-rommon_1_0

104],

Currently running ROMMON from ROM 0

BOOTLDR:7300 Software (C7300-BOOT-M), Version 12.1(1.23.61), CISCO

DEVELOPMENT TEST VERSION

Router uptime is 3 minutes

System returned to ROM by power-on

System image file is

"tftp://223.255.254.254/muck/nlaw/c7300-js-mz.121-99."

cisco 7300 (NSE100) processor (revision B) with 114688K/16384K bytes of

show running-config Displays the running

configuration file

Router# show running-config

show startup-config Displays the configuration

stored in NVRAM

Router# show startup-config

Table 4-3 Using show Commands (continued)

Command Function Example

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50

Comentarios a estos manuales

Sin comentarios

Cisco 7300-6T3 Especificaciones Pagina 44

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco 7300-6T3