Cisco 7300-6T3 Especificaciones Pagina 49

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 50
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 48
4-13
OC12 Packet Over SONET Line Card Installation and Configuration
OL-3437-01
Chapter 4 Configuring the OC12 POS Line Card
CLI-Controlled OIR
Note Contact the Technical Assistance Center (TAC) for assistance with these error messages. To contact the
TAC, see the Obtaining Technical Assistance section on page ix.
CLI-Controlled OIR
Line cards can be removed from the Cisco 7304 router without disrupting data flow by using the
hw-module slot slot # stop/start command in EXEC mode. The hw-module slot slot # stop command
will stop traffic, shut down all line card interfaces, and deactivate the line card. The hw-module slot slot
# start command resets the line card, puts the line card back online, and turns off the OIR LED. To
remove and install an active line card in slot 2, proceed as follows:
Router# hw-module slot 2 stop
When the OIR LED turns green, the line card in slot 2 has been deactivated and can be physically
removed and replaced with a new line card (see the Line Card Removal and Installation section on
page 3-3).
When the new line card is inserted in slot 2 it is automatically reset, put online, and the OIR LED is
turned off.
Vista de pagina 48
1 2 ... 44 45 46 47 48 49 50

Comentarios a estos manuales

Sin comentarios