Cisco ATA-186 Guía de usuario descargar pdf (Pagina 4)

Cisco ATA 186 Configuration Guide

Welcome

Overview

This document contains information that will help you configure the Cisco®

ATA 186 Analog Telephone Adaptor to place calls on the Net2Phone network.

IMPORTANT: The firmware on your device must be version 2.14 or

higher. If you have an older version, you must upgrade through Cisco

before proceeding.

To find out the firmware version on your device, access the Web

Configuration page. The firmware version is displayed in the bottom left-

hand corner.

For additional information on installing and configuring the ATA 186, please

refer to the User’s Guide located on the following Web site:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/index.htm

For SIP 3.1.0 Firmware release notes:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/atarn/atarn3_1.

htm

Requirements

 Access to a Broadband Internet Service Provider (ISP) or Local Area

Network

 A Net2Phone account number and PIN for each phone port

(Contact your local distributor for an account and PIN if you do not

have one.)

 Any conventional analog telephone

 A Cisco ATA 186

Support

For all technical issues regarding the use of the ATA 186 on the Net2Phone

network, please contact your local reseller.

Setting Up Your ATA 186

If your ATA 186 is not currently set up, please follow the steps below.

1. Connect the ATA 186 to your Ethernet port.

• Plug one end of an Ethernet cable (RJ-45) into the Ethernet

port on the back of the device.

• Plug the other end into a broadband router or LAN port.

2. Connect your telephone into the ATA 186.

Page 1

1 2 3 4 5 6 7 8 9 ... 22 23

Sin comentarios

Cisco ATA-186 Guía de usuario Pagina 4