Cisco PA-E3 Especificaciones descargar pdf (Pagina 30)

Installing a Port Adapter

PA-E3 Serial Port Adapter Installation and Configuration

4-4

Figure 4-3 Pulling a Port Adapter Out of a Slot—Partial Port Adapter View

Step 8

If you removed a port adapter, place it in an antistatic container for safe storage or

shipment back to the factory. If you removed a blank port adapter, no special handling is

required; however, store the blank port adapter for potential future use.

This completes the procedure for removing a new port adapter on a Catalyst RSM/VIP2.

Installing a Port Adapter

The following is the standard procedure for replacing a port adapter on the Catalyst RSM/VIP2:

Step 1 Attach an ESD-preventive wrist strap between you and an unﬁnished chassis surface.

Step 2 Remove the new port adapter from its antistatic container and position it at the opening

of the slot.

Step 3 Carefully align the port adapter carrier between the upper and the lower edges of the port

adapter slot, as shown in Figure 4-4.

H3149

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 67 68

Sin comentarios

Cisco PA-E3 Especificaciones Pagina 30