Cisco PA-E3 Especificaciones Pagina 67

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 68
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 66
Configuring the PA-E3 Interfaces 8-21
Using the loopback Command to Verify the Physical Interface
Set the interface into network payload loopback mode as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
router(config)# interface serial 10/0/0
router(config-if)# loopback network payload
Network payload loopback loops just the payload data back toward the network at the E3 framer.
Vista de pagina 66
1 2 ... 62 63 64 65 66 67 68

Comentarios a estos manuales

Sin comentarios