Cisco Unified Videoconferencing Manager Manual de usuario Pagina 102

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 117
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 101
Using a Polycom CMA System as a Gatekeeper
Polycom, Inc. 95
d Once complete, click Save.
13 Repeat this step for each prefix range in the H.323 network.
Once you complete the above steps, any Cisco IP phone attached to your Cisco
Unified Communications Manager is able to call any gatekeeper registered
extension.
Configuring CMA for Cisco Unified Communications Manager
The Polycom CMA system must be configured with routing information
similar to that found in Cisco Unified Communications Manager. This allows
calls from the H.323 network to reach devices inside Cisco Unified
Communications Manager.
To configure CMA for Cisco Unified Communications Manager calls:
1 Log into the CMA system.
2 Navigate to Network Device > Monitor View.
3 Verify that your Cisco Unified Communications Manager is in the device
list. If it does not appear, reset the trunk in Cisco Unified
Communications Manager.
4 Navigate to Admin > Dial Plan and Sites > Dial Rules.
5 Click Add to add a dial rule.
Note
If a route pattern is pointed directly at a trunk, any subsequent route patterns that
get added will reset and drop ALL calls on the trunk. The use of route groups and
route lists allows calls to stay active while adding route patterns.
Vista de pagina 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 116 117

Comentarios a estos manuales

Sin comentarios