Cisco WAP200 - Small Business Wireless-G Access Point Especificaciones descargar pdf (Pagina 27)

Configuring the WAP200 Access Point

Setting Up Your Access Point

Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 21

Configuring Basic Setup Settings

To configure the basic setup settings of the access point, follow these steps:

STEP 1 Click Setup > Basic Setup.

STEP 2 In the Basic Setup section, configure the following settings:

• Host Name—Enter the host name of the access point.

You can use the host name to access the web-based configuration utility

through the network if a record of the host name exists in your DNS server.

The access point publishes the host name to your DNS server if you

configured the access point to acquire the IP address from a DHCP server.

Follow your organization’s policy when assigning this name. The default

name is Cisco.

• Device Name—Enter the device name for the access point.

This name is only for identification purposes, for your convenience. Unique,

memorable names are helpful, especially if you are employing multiple

access points on the same network. This name helps you identify the

access point after you log in.

The default name is WAP200.

STEP 3 Click Save.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 94 95

Sin comentarios

Cisco WAP200 - Small Business Wireless-G Access Point Especificaciones Pagina 27