Cisco 2500 SERIES Especificaciones descargar pdf (Pagina 14)

Step 3 Place the switch on the table or shelf near an AC power source.

Note Allow 3 inches of space around the controller ventilation openings to prevent airflow

restriction and overheating.

Step 4 After the controller is mounted on a shelf or desk, perform the following tasks to complete

the installation:

• Connecting the Controller Console Port

• Securing the Power Adapter Cable

• Connecting to the Network

Step 5 For configuration instructions about using the CLI setup program, see the “Running the

Bootup Script and Power-On Self Test” section on page 24.

Mounting the Controller on a Wall (Rack-Mount Brackets)

The controller can be mounted on a wall using an optional rack-mount bracket kit that is not included

with the controller. You can order a kit with 19-inch rack mounting brackets and hardware from

Cisco. The kit part number is AIR-CT2504-RMNT.

Warning

Read the wall-mounting carefully before beginning installation. Failure to use the

correct hardware or to follow the correct procedures could result in a hazardous

situation to people and damage to the system.

Statement 378

To mount the controller on a wall using rack-mount brackets, follow these steps:

Step 1 Attach the 19-inch brackets to each side of the 2504 controller as shown in Figure 5 with

#10-32 flat head screws provided in the kit.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 57 58

Sin comentarios

Cisco 2500 SERIES Especificaciones Pagina 14