Cisco 2500 SERIES Especificaciones descargar pdf (Pagina 8)

Note Wait at least 20 seconds before reconnecting an access point to the controller. Otherwise, the

controller may fail to detect the device.

Note From the AireOS V 7.3 onward, APs can be connected directly to all ports. However the PoE

powering to the APs is not fully supported. Power Injectors or external power source for APs

is needed.

Note Precautions for the direct AP connection: Do not configure interfaces on the physical

ports, if AP is connected to the port. If an interface is configured on the port where AP is

connected, the behavior is undefined. If the physical ports are configured, remove it and

reload the controller.

Figure 3 shows the back panel and identifies its components. Table 2 describes the back panel

components.

Figure 3 Controller Back Panel and Components

282250

POWER 48VDC

Cable Lock

Slot

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 57 58

Sin comentarios

Cisco 2500 SERIES Especificaciones Pagina 8