Cisco OSM-12CT3/T1 - Optical Services Module Multiplexor Guía de instalación descargar pdf (Pagina 29)

1-29

Cisco 7600 Series Internet Router Module Installation Guide

78-12798-07

Chapter 1 Product Overview

Catalyst 6000 Family Modules

• NEXT—Use this push button switch to scroll to the next item on the LCD

display menu.

Switch Fabric Module 2 (WS-X6500-SFM2)

Note The Switch Fabric Module 2 is not supported on the Cisco 7603 Internet

Router.

The Switch Fabric Module 2 (WS-X6500-SFM2), shown in Figure 1-24, requires

a Supervisor Engine 2 and must be installed in slots 5 or 6 of the Cisco 7600 series

Internet Router.

For redundancy, you can install a second Switch Fabric Module 2. The Switch

Fabric Module 2 that is installed first functions as the primary module. When you

install two modules at the same time, the module in slot 5 functions as the primary

module, and the module installed in slot 6 functions as the backup. If you reset

the Switch Fabric Module 2 installed in slot 5, the module in slot 6 becomes the

primary module.

Figure 1-24 Switch Fabric Module 2 (WS-X6500-SFM2)

Two front-panel LEDs provide status information for the module and indicate

whether the module is active. The STATUS LED functions are listed in Table 1-15

on page 1-30. (The ACTIVE LED is green when the module is operational and

active, and is orange when the module is in standby mode.)

51177

SWITCH FABRIC MDL

STATUS

SELECT

WS-X6500-SFMIA

ACTIVE

STATUS LED

ACTIVE LED

2 Line X 20 character

LCD display

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Cisco OSM-12CT3/T1 - Optical Services Module Multiplexor Guía de instalación Pagina 29