Cisco DPA 7610 Manual de usuario descargar pdf (Pagina 16)

Known Issues

78-12814-03

CSCdu07314 Some ports on the DPA 7630 are

off-hook after restart.

When connected to an Octel 200 system, some

ports on the DPA 7630 might appear to be in the

“off hook” state while the DPA 7630 is starting

up. Ports also might not answer calls. The Octel

200 reports these ports to be in “NDT” state (via

the pstat command).

This behavior stops shortly after the DPA 7630

has started up and all the ports register

successfully with Cisco CallManager. This occurs

because the Octel system performs a self test on

the ports as they become available. The Octel 200

goes off hook and checks for dial tone.

However, this test might fail while the ports are

registering with the Cisco CallManager. The

Octel will then retry the test after two minutes, by

which time the ports will have stabilized and the

test will pass.

Calls through the DPA 7630 should not be made

until all the Octel 200’s ports that are connected

to the DPA have successfully come up, and are in

“IDL” state (as reported by pstat).

CSCdu14733 During restart, a warning stating

that the Cisco CallManager

connection has gone down

appears for some of the ports on

the DPA 7630/7610.

This can be caused by several factors during the

startup process. However, once all the ports have

come up, the warnings should not re-occur.

You can safely ignore these warnings during the

startup process.

Table 3 DPA 7630/7610 Known Issues (continued)

Bug ID Summary Explanation

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Cisco DPA 7610 Manual de usuario Pagina 16