Cisco InfiniBand 4x Guía de usuario descargar pdf (Pagina 83)

Chapter 4. Configuring InfiniBand with QLogic bridges 69

7. Repeat steps 4 through 6 for the other VFx Controller. There are a total of two controllers.

When the driver instillation is complete, you see two SilverStorm VFx I/O Controllers under

SCSI and RAID Controllers in Device Manager as shown in Figure 4-52.

Figure 4-52 VFx Controllers in Device Manager

The VFx Controllers will have exclamation points (!) on them until an SRP mapping is

created. Each bridge module has two IO Controllers (IOC), thus the two VFx controllers in

Device Manager.

8. Open the Web interface of your bridge module. Then, click SRP Initiator Discovery and

Start. The bridge module discovers your InfiniBand HCA and creates four Extended SRP

IDs per HCA port as shown in Figure 4-53. These IDs are later mapped to the remote

drives on the storage target.

Figure 4-53 Discovered SRP Initiators

In this example, only one InfiniBand switch was present in the BladeCenter chassis, so

only one InfiniBand HCA port was available to the bridge module.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 173 174

Sin comentarios

Cisco InfiniBand 4x Guía de usuario Pagina 83