Cisco 1417 - 1417 Router - EN Manual de usuario descargar pdf (Pagina 11)

WAN

ACT

Yellow

Blinking when the xDSL port receives or

transmits data.

Cisco 678

The ADSL port uses an RJ−11 connector.

ADSL Port Pinouts

Signal

Ring

Tip

Note: Pins 1, 2, 5, and 6 are not used.

WAN Link and Powerup Issues

This is the normal sequence of events when you power up the router:

The ALARM light comes on within five seconds, flashes for half a second, then goes off.1.

Between one and ten seconds after the ALARM light goes off, the WAN LNK light starts to blink.

This indicates that the router attempts to establish communication with the service provider modem in

the central office.

After communication is established, the WAN LNK light remains on.3.

Under normal conditions, the ALARM light is off within six seconds of powering up the router, and within

one minute the WAN LNK light is on.

If the router does not establish communication with the service provider modem, the WAN LNK light goes

off. The router waits ten seconds. The WAN LNK light starts to blink when the router tries again to establish

communication.

If the WAN LNK light continues to blink after attempts to establish communication, turn off the power and

then turn it on. If the WAN LNK light still does not become solid within one minute, call your service

representative.

If the ALARM light flashes RED or lights RED and stays on, call your service representative.

Note: With the POWER light on, the WAN LNK light appears off under certain circumstances, even though

the Cisco 678 operates correctly. This condition occurs, for instance, if there is no data traffic across the WAN

LNK for two minutes or more. In this case, the PPP session times out. and the WAN LNK light goes off.

During subsequent requests for data across the link, the WAN LNK light starts to blink. This indicates that the

ADSL connection sequence has started.

Cisco 802 IDSL and 804 IDSL

If your wall jack has an RJ−11 connector, attach the RJ−45−to−RJ−11 adapter cable to the red cable. Connect

the RJ−11 connector to the IDSL wall jack.

Cisco − DSL Modem/Router Interface Pinouts and Status LED Descriptions

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

Cisco 1417 - 1417 Router - EN Manual de usuario Pagina 11