Cisco 1417 - 1417 Router - EN Manual de usuario descargar pdf (Pagina 9)

WAN LNK

WAN Link

Blinks during ADSL line training

activities. When the light blinks

several times and then stops, the

central office equipment is

unavailable. On when a link has

been established on the WAN port.

When the light is on, the Cisco 675

is connected and trained.

WAN−ACT WAN

Activity

Blinks when the WAN port

transmits or receives data

LAN LNK (Ethernet)

LAN Link

On when a link has been

established on the Ethernet port

LAN−ACT

(Ethernet)

LAN

Activity

Blinks when there is activity on the

Ethernet port

PWR/ALARM Power

Light

Green when the Cisco 675 is on

and works correctly. Red when the

Cisco 675 is on but there is a

problem or alarm that needs to be

resolved

Cisco 676

The ADSL port on the Cisco 676 uses an RJ−11 connector.

ADSL Port Pinouts

Signal

Ring

Tip

Note: Pins 1, 2, 5, and 6 are not used.

WAN Link and Powerup Issues

During normal operation the ALARM LED blinks once after the unit is turned on. If the LED continues to

blink or stays on, call your service representative.

The WAN LNK LED is on and blinks while the modem trains up to the network. When you power up the

modem and the modem operates correctly, the WAN LNK LED remains on.

If theWAN LNK LED does not stay on or does not light at all after 45 seconds:

Check all cabling and connections.1.

Turn off the power and then turn it on again.2.

If the LED is still not on, call your service representative.3.

Cisco − DSL Modem/Router Interface Pinouts and Status LED Descriptions

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentarios a estos manuales

Sin comentarios

Cisco 1417 - 1417 Router - EN Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Cisco 1417 - 1417 Router - EN