Cisco 1417 - 1417 Router - EN Manual de usuario descargar pdf (Pagina 4)

Cisco SOHO78

xDSL Port Pinouts

LED Descriptions

Cisco 1401

ATM−25 Cable

ATM Loopback Plug

Front−Panel LED Descriptions

Cisco 1417

ADSL Cable

POTS Crossover Cable

Front−Panel LED Descriptions

Cisco WIC−1 ADSL

Wiring

LED Descriptions

Connect the ADSL WAN Interface Card to the Network

NetPro Discussion Forums − Featured Conversations

Related Information

Introduction

This document describes the port pinouts and LED statuses for specific Cisco digital subscriber line (DSL)

devices.

Note: The terms "port pinouts" and "connector pinouts" are used interchangeably. In this document, pinouts

are named "port pinouts."

If you experience problems with the DSL connection on these devices, verify these :

The DSL cable between the Network Interface Device (NID)/wall jack/splitter and the Cisco DSL

customer premises equipment (CPE) modem/router is the correct type.

•

The correct NID is being used. If the NID is installed by a Telco, the Telco must verify its

functionality.

•

DSL Status LEDs show proper operation.•

Note: Not all DSL CPE modem/router products use the same DSL interface port pinouts.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Cisco − DSL Modem/Router Interface Pinouts and Status LED Descriptions

1 2 3 4 5 6 7 8 9 ... 19 20

Sin comentarios

Cisco 1417 - 1417 Router - EN Manual de usuario Pagina 4