Cisco 1417 - 1417 Router - EN Manual de usuario descargar pdf (Pagina 19)

equipment at the service provider office

(Cisco 1417 Router).

ACT

Green

Blinks when data is sent to or received

from the ATM−25 port (Cisco 1401

Router) or the ADSL port (Cisco 1417

Router).

Yellow

On when the ATM−25 port (Cisco 1401

Router) or the ADSL port (Cisco 1417

Router) is in loopback mode.

Cisco WIC−1 ADSL

Wiring

The RJ−11 connector provides xDSL connection to external media through standard RJ−11 6−pin modular

jacks.

Description

XDSL_Tip

XDSL_Ring

LED Descriptions

LED

Description

CD (carrier detect)

Green when trained

LP (loopback)

Yellow during loopback

Green when ok

Connect the ADSL WAN Interface Card to the Network

To connect the ADSL WAN Interface Card (WIC) to the network, use the standard lavender RJ−11 cable that

comes with your card.

Note: If you connect a Cisco router with an ADSL card to an RJ−11 wall jack that has the ADSL pair wired

for pins 2 and 5, use the lavender crossover cable with the blue stripe. The crossover cable can be ordered as a

spare part.

These steps describe how to connect the WIC with the help of the standard lavender RJ−11 cable. However, it

also applies to connecting the WIC with the lavender crossover cable with the blue stripe.

Confirm that router is turned off.1.

Connect one end of the RJ−11 cable to the ADSL port on the card.2.

Connect the other end of the cable to the RJ−11 wall jack at your site.3.

Enter the no shut command in the router configuration.

You must configure the ADSL card in the router to the no shutdown state to connect the card to the

Cisco − DSL Modem/Router Interface Pinouts and Status LED Descriptions

1 2 ... 14 15 16 17 18 19 20

Sin comentarios

Cisco 1417 - 1417 Router - EN Manual de usuario Pagina 19