Cisco 2525 Guía de usuario descargar pdf (Pagina 122)

A-10 Cisco 2524 and Cisco 2525 Router User Guide

Upgrading the DRAM SIMM

Figure A-4 Removing and Replacing the DRAM SIMM

Step 6

Using the system card orientation shown in Figure A-4, position the new SIMM

so that the polarization notch is located at the right end of the SIMM socket.

Step 7 Insert the new DRAM SIMM by sliding the end with the metal ﬁngers into the

SIMM connector socket at approximately a 45-degree angle to the system card.

Gently rock the SIMM back into place until the latch on either side snaps into

place. Do not use excessive force because the connector may break.

Step 8 Replace the router cover. Follow the instructions in the section “Closing the

Chassis” later in this appendix.

Step 9 Connect the router to a console terminal.

Step 10 Turn ON power to the router. If error messages relating to memory are displayed,

remove the DRAM SIMM and reinstall it, taking care to ﬁrmly seat the SIMM in

its socket.

Polarization notch

DRAM SIMM card

Pull the tabs away with

your thumbs, bracing your

forefingers against the

posts. Raise the SIMM

to a vertical position.

H3558

Connector edge of

the system card

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 165 166

Sin comentarios

Cisco 2525 Guía de usuario Pagina 122