Cisco 2525 Guía de usuario descargar pdf (Pagina 126)

A-14 Cisco 2524 and Cisco 2525 Router User Guide

Closing the Chassis

Replacing the Cover

After you perform the maintenance for your system, perform the following steps to replace

the cover:

Step 1 Position the two chassis sections, as shown in Figure A-6.

Step 2 Referring to Figure A-6, press the two chassis sections together and ensure the

following:

• The top section ﬁts into the rear of the bottom section. (See A in Figure A-6.)

• The bottom section ﬁts into the front of the top section. (See B in Figure A-6.)

• Each side of the top and bottom sections ﬁts together. (See C in Figure A-6.)

Caution To ﬁt the two sections together, it may be necessary to work them together at one

end and then the other, working back and forth; however, use care to prevent bending the

chassis edges.

Figure A-6 Replacing the Chassis Cover

Step 3

When the two sections ﬁt together snugly, turn the chassis so that the bottom is

facing up, with the front panel toward you.

Step 4 Replace the cover screw. (See Figure A-2.) Tighten the screw to no more than 8 or

9 inch/pounds of torque.

H3560

FrontRear

Left end

toward you

Top section

Bottom section

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 165 166

Sin comentarios

Cisco 2525 Guía de usuario Pagina 126