Cisco 3002 - VPN Hardware Client Especificaciones descargar pdf (Pagina 14)

Caveats

Release Notes for Cisco VPN 3002 Hardware Client Release 3.1

78-13771-01

• CSCdt49326, CSCdu57255

When the VPN 3002 is configured for 10 Mbps and the duplex mode is

configured for auto, the duplex mode made be incorrectly displayed in the

Monitor | Statistics | MIB II | Interfaces | Ethernet screen as "half" duplex

even though it is running at "full" duplex.

• CSCdu40803

The 3002 may reboot after several hours of failed authentication attempts

during PPPoE negotiation. Make sure the correct name and password are

configured.

• CSCdu50355

When you view the VPN 3002 ARP table with PPPoE enabled, entries for

Interface 12 appear. Interface 12 is currently being used as the PPPoE

interface.

• CSCdu52733

When the route table for a VPN 3002 with PPPoE enabled is displayed on

either the CLI or HTML interface, the following two routes appear in the

table. Ignore them.

Address Mask Next Hop Int

0.0.0.0 0.0.0.0 133.3.0.40 12

0.0.0.0 255.0.0.0 0.0.0.0 public in

• CSCdu63947

When the VPN 3002 initially boots with PPPoE enabled, it generates an ARP

request for address 0.0.0.1. This is the temporary IP address for the physical

public interface.

• CSCdu66046

On a VPN 3002 configured for PAT mode, after an IPSec rekey occurs, the

Assigned IP Address field does not display on the System Status window.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Cisco 3002 - VPN Hardware Client Especificaciones Pagina 14