Cisco 3002 - VPN Hardware Client Especificaciones descargar pdf (Pagina 4)

Installation Notes

Release Notes for Cisco VPN 3002 Hardware Client Release 3.1

78-13771-01

Installation Notes

For complete installation information, refer to the VPN 3002 Hardware Client

Getting Started guide. To install and configure the VPN 3002 using default

values, see the VPN 3002 Quick Start card, which ships with the VPN 3002.

Initial Configuration

You must meet these requirements to configure the VPN 3002.

Central-site Concentrator Requirements

To interoperate with a VPN 3002, the VPN 3000 Series Concentrator to which it

connects must:

• be running software version 3.0 or later.

• configure IPSec group and user names and passwords for this VPN 3002.

• for a VPN 3002 running in PAT mode, enable a method of address

assignment: DHCP, address pools, per user, or authentication server address.

• for a VPN 3002 running in Network Extension mode, configure either a

default gateway or a static route to the private network of the VPN 3002.

See Chapter 3, “Quick Configuration using the VPN 3002 Hardware Client

Manager,” in the VPN 3002 Hardware Client Getting Started manual for

step-by-step Quick Configuration instructions.

Configuration Interfaces

For easiest use, we strongly recommend using the VPN 3002 Hardware Client

Manager (referred to in these Release Notes as the Manager), which is

HTML-based, from a PC and browser. The PC must be able to run the

recommended browser.

You can also configure and manage the VPN 3002 using:

• a PC attached to the console port via the command-line interface (CLI). The

console can be the same PC that runs the browser.

• Telnet, Telnet/SSL, or SSH via the private LAN.

1 2 3 4 5 6 7 8 9 ... 19 20

Sin comentarios

Cisco 3002 - VPN Hardware Client Especificaciones Pagina 4