Cisco 4510R - Catalyst Switch Manual de usuario descargar pdf (Pagina 10)

redundancy force−switchover command first checks that the redundant supervisor engine is in the correct

state. If you issue the reload command and the status is not Standby Hot, the reload command only resets the

current supervisor engine.

Access the Standby Supervisor

The Catalyst 4500 Supervisor IV in a 4507R allows the active supervisor to perform activities on the standby

supervisor devices. This table lists some of the common activities.

Commands

Description

dir slavebootflash:

dir slaveslot0: Used to list the contents of the standby

bootflash: device or slot0:

delete

slavebootflash:<filename

delete

slaveslot0:<filename> Used to delete a specific file name from

the standby devices.

squeeze

slavebootlflash:

squeeze slaveslot0: Used to perform the squeeze function

after delete to recover the device space.

format

slavebootflash:

format slaveslot0:

Used to format the standby devices.

copy <source>

slavebootflash:

copy <source>

slaveslot0:

Used to copy files to the standby

devices. Source device can be TFTP or

active supervisor devices.

Issue the show diagnostics power−on standby command in order to access the standby supervisor power−on

diagnostics.

Supervisor Uplink Redundancy

In the Catalyst 4500 Series, if Supervisor redundancy has been configured, only specific uplink ports are

active and available for uplink connectivity. If you try to configure other uplink ports, an error message

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Sin comentarios

Cisco 4510R - Catalyst Switch Manual de usuario Pagina 10